WILSON TUNABLE COLORFUL CLONE WAH
Non DisponibileModeled after the infamous Macari wah with it's deep throaty sweep and sound the Tunable Colorful Clone was tuned to it's stock setting side by side with my very own Macari wah. This wah will come set to the vintage Macari sound but, there is more. The Tunable Colorful Clone has more exterior controls than any other Wilson wah. At the front of the pedal you have the sweep control. This allows you to add or take away depth from the sweep. Behind that there is a midrange control knob. This will allow you to add even more throat to the sweep or you can smooth it out some. The type of control used will allow for quite a difference in the sound of the sweep if you desire to tune it that way. The next control is the Q control. There are six additional positions allowing you to go one position deeper than the stock setting of the pedal or you have four additional fine tuning Q positions that allow you to get various other vintage tones from this pedal. Of course at the heel of the pedal is the growl control. This allows you to make the sweep of the Tunable Colorful Clone even deeper or you can lighten it up a bit. Inside the pedal is the volume control that will allow you to adjust the pedal to unity gain or boost the signal so you can cut through the mix. The Tunable Colorful Clone comes with a built in fuzz buffer with this volume control included. This allows you to tune the pedal to unity gain or to boost the signal above unity so you can cut through the mix in a live setting. All of our pedals are built with a true bypass circuit therefore not sucking the life out of your signal when in bypass mode. The Tunable Colorful Clone operates on an industry standard 2.1mm center negative power supply or a high quality alkaline battery.